Nickel Plated Brass Press-fit Tube Fittings
Metal Run Tee
Sizes available:
- 8mm x 1/8" BSP
- 8mm x 1/4" BSP
The "Sistem Pneumatica" push-in fittings were originally designed for use in industrial equipment that operate with low-pressure compressed air as the primary fluid for movement. Although the construction of these fittings provides even higher performance than reported, it is the user's responsibility to consider any use outside the field or performance requirements specified on the technical sheets.
The push-in fittings use a gasket located outside the tube to seal it, ensuring that the tube can fully pass through the fitting. The internal structure of the fittings and the sealing system implemented allow for use in plants with applications of industrial vacuum (-75kPa).
SUITABLE FOR
RILSAN (PA11/12), POLYURETHANE, POLYETHYLENE, POLYESTERE, TEFLON, NYLON (PA6): ±0,05 (Ø4÷Ø10) - ±0,1 (Ø12÷Ø14)
Metal Line Fittings Main Technical info
