Overview
Plasson offers the most extensive range in Compression Fittings for PE Pipes (low & high density) on the market. Its compact design, easiness of installation and reliability has been tested by the European Certification and Qualification Association.
Note:
- Brass Hose taps do not connect directly into the wing-back, use a Hansen threaded bush or nipple in between.
Medium Density Fittings
Used for:
- Medium Density Pipe
- Blueline
- SKU: 2500-(OD Pipe Size)PN12-5-(Coil Length)
- e.g 2500-25PN12-5-100 (25mm = OD size, PN12.5 = Bar, 100 = Coil Length)
- Redline
- SKU: 360-(OD Pipe Size)PN(Bar Rate)-(Coil Length)
- e.g 360-63PN9-100 (63mm = OD size, PN9 = Bar, 100 = Coil Length)
- Greenline
- SKU: 370-(OD Pipe Size)PN(Bar Rate)-(Coil Length)
- e.g 370-32PN8-100 (32mm = OD size, PN8 = Bar, 100 = Coil Length)
- Blueline
Tips:
- Medium-density pipe is referred to by its outside diameter (OD)
- Medium Density Fittings go overtop of MD Pipe
- The pipe needs to be pushed past the o-ring in the MD fitting to seal
- If the MD pipe is scratched or gouged, it may not create a seal on the o-ring and leak.
- Use tools to tighten