Overview
Capping or removing a sprinkler is done differently depending on whether or not you live in an area that freezes and requires the irrigation system to be winterized. Winterizing your irrigation system involves draining or blowing the water out of the system with compressed air to prevent freeze damage.
Use these instructions if you live in an area that does not require winterization
- To cap off a sprinkler, dig up the dirt around the head you want to remove exposing the pipe and fittings below.
- Unscrew the sprinkler and any piping connecting the sprinkler to the fitting below.
- Install a cap or plug of the appropriate size/thread to stop water from flowing out of the fitting after the sprinkler is removed. Note: Teflon tape is recommended when using a threaded cap.
- Turn on the irrigation to check for leaks before burying the pipe and fitting.
Use these instructions if you live in an area that does require winterization
If the sprinkler you want to remove is the last one on the pipe, you will need to locate the sprinkler that is “upstream” (closer to the source of water from the sprinkler you want to remove), cut and cap off the pipe there. Capping the pipe at the upstream sprinkler prevents a “dead end” of pipe that would fill with water but not have any outlet. During winterization, the water could get trapped in the “dead end” and potentially freeze, breaking the pipe.
- Dig up the pipe and fitting prior to the upstream head.
- Cut the pipe just past the tee fitting leaving enough pipe sticking out of the tee to cap it. You can use approved PVC glue with a slip end cap to attach to the pipe. These can easily be found in any hardware retail center in the size needed.
- Dig up the dirt around the sprinkler you want to remove and unscrew it from the fitting beneath it. The pipe can be abandoned, as it is no longer connected to the irrigation system.
- Turn on the irrigation to check for leaks before burying the pipe and fitting.
